ShapeFlt:

--------------------------------------------------------------------------
   Generates a shaping filter with notches and first order roll off.
   If no outputs are specified it will generate a Bode plot of the 
   continuous system. The widths of the notches should be proportional 
   to the center frequency.

   For example wN = 0.01 and width = 0.001 will look the same as
   wN = 0.001 and width = 0.0001.

   Since version 2.
--------------------------------------------------------------------------
   Form:
   [a, b, c, d] = ShapeFlt(  wN, width, depth, wL, tSamp, sType )
--------------------------------------------------------------------------

   ------
   Inputs
   ------
   wN            (m)     Center of notch         (rad/sec)
   width         (m)     Width of notch          (rad/sec)
   depth         (m)     Filter depth            (dB)
   wL            (1,1)   Low pass cutoff         (rad/sec)
   tSamp         (1,1)   Sampling period         (sec)
   sType         (1,1)   State equation type     ('Delta' or 'Z')

   -------
   Outputs
   -------
   a             (n,n)   State matrix
   b             (n,1)   Input matrix
   c             (1,n)   Output matrix
   d             (1,1)   Feedthrough matrix

--------------------------------------------------------------------------

Children:

Common: Control/C2DZOH
Common: Control/C2DelZOH
Common: Control/FResp
Common: Control/ND2SS
Common: Control/Notch
Common: Control/Series