ACPointMassControl:

Path: ACPro/ACProControl

% Point mass control of flight path angle, velocity and angle of bank.

 The controller controls velocity and angle of climb. dC.mode can be
 'takeoff', 'climb' or 'bank'. It will automatically transition to
 climb if the velocity exceeds the takeoff velocity. The routine
 uses a combination of feedforward and feedback compensation.

 When banking, the aircraft does not climb. However, you can set a
 bank angle during climb.

 This function has two data structures. dC has the control specific
 data and dAC is aircraft data. dAC is the same datastructure used
 in RHS3DPointAircraft.m. 
--------------------------------------------------------------------------
   Form:
   dC = ACPointMassControl( x, p, dAC, dC )
--------------------------------------------------------------------------

   ------
   Inputs
   ------
   x   (7,1)	State [v;gamma;psi;x;y;h;m] (metric)
   p   (1,1)	Standard atmosphere data structure
   dAC	(1,1)	Data structure for aircraft
           	.lDData     (1,1) Lift/drag data structure
             .cDCL       (1,1) Pointer to lift/drag function
             .thrust     (1,1) Pointer to the thrusst function
             .thrustData (1,1) Thrust data structure
             .lDData     (1,1) Lift/drag data structure
   dC 	(1,1)	Control Data structure
             .vSet       (1,1) Setpoint for velocity
             .gammaSet   (1,1) Setpoint for flight path angle
             .bankSet    (1,1) Setpoint for bank angle
             .vTakeoff   (1,1) Takeoff velocity
             .mode       (1,:) Mode name

   -------
   Outputs
   -------
   dC  (1,1)	Control data structure outputs
             .throttle (1,1) Throttle setting (0 to 1)
             .alpha    (1,1) Angle of attack (rad)
             .phi      (1,1) Bank angle

--------------------------------------------------------------------------
   See also RHS3DPointAircraft
--------------------------------------------------------------------------

Back to the ACPro Module page