BuildFlatPlates:

Path: SC/Demos/CAD

% Simple model with two thin plates. 
 Create a CAD model with two thin boxes. This mimics the effect of two solar
 panels which often dominate the disturbances at higher altitudes. After the
 model is finished it is displayed. The 'FlatPlates' model is then saved to
 SCModels.

  ------------------------------------------------------------------------ 
  See also BuildCADModel, CreateComponent, DrawSCPlugIn
  ------------------------------------------------------------------------
%
--------------------------------------------------------------------------
  	Copyright (c) 2000-2003, 2015 Princeton Satellite Systems, Inc.
   All rights reserved.
--------------------------------------------------------------------------

Children:

AeroUtils: CAD/BuildCADModel
AeroUtils: CAD/CreateBody
AeroUtils: CAD/CreateComponent
Common: FileUtils/FindDirectory
Common: General/SaveStructure

Back to the SC Module page